Before start up
Check oil and water levels (hydraulic oil after start up)	YES NO N/A
Complete a walk round inspection	YES NO N/A
Are all high pressure connections chained?	YES NO N/A

After start up (before moving off)
Check instruments are reading correctly	YES NO N/A
Check the lights are OK	YES NO N/A
Check the operation of the air conditioning/filtration (where applicable)	YES NO N/A

Prior to drilling
Is suitable crest protection or fall arrestment equipment available?	YES NO N/A
Are holes marked and have you a suitable drill log sheet?	YES NO N/A

During Operation
Inspect for oil, water, or fuel leaks and unusual smells or noises	YES NO N/A
Grease – in accordance with manufacturer’s instructions	YES NO N/A
Are the holes properly sealed by the rubber skirt?	YES NO N/A
Is the dust extraction equipment fully operational?	YES NO N/A

At end of shift
Drain the air tanks	YES NO N/A

General
Are there any obvious signs of cracks, overhangs on/behind the face?	YES NO N/A
Is the brake operational?	YES NO N/A
Is your shelter up wind of the rig?	YES NO N/A
Is the compressor on level ground?	YES NO N/A